No replies to this topic

[mestizo]

This post was taken from my build thread it shows basically how you install fender braces on an S13.

Shit what a difference in stiffness and steering response! I'm defintely happy with this purchase!

Started with pulling the front end off the car.


This is where the fender brace will go.


Remove 3 bolts from the door brackets


Now u just put the brace in place with the original bolt's, then u put the rear nut/stud plate in the rectangular hole you see in the pic. Now u snug up the bolts to center the brace and center punch where the smaller of the 2 holes is.




Now you remove the nut/stud plate and drill out the 2nd hole where it was center punched.


3/8" Hole drilled.


Nut/stud plate reinstalled and bolted down tight.


DONE!